PROBLEM: HA5000 waveforms not saved during decoding

PROBLEM: HA5000 waveforms not saved during decoding.

Last reviewed: November 29, 2001
Article ID: 011129sab

The information in this article applies to:

Pronto for Windows 32 bit releases 5.00 to 5.06.

Symptoms

When playing back data from an HA5000 Harmonics Analyser the waveforms are not saved in the project.

Cause

If any two waveforms are more than approximately one and a half days apart the time interval between them is incorrectly decoded. The waveform data then fails consistency checks and is rejected. This problem was introduced during the development of the 32 bit release of Pronto for Windows.

Resolution

Any of the following:

Upgrade Pronto for Windows to release 5.07 or later.

Use a shorter recording period to ensure that the time between waveforms is less than one and a half days.

Use a 16-bit release of Pronto for Windows, for example 4.57, to playback data from the HA5000.

Back to Knowledge Base index

THE INFORMATION PROVIDED IN THE PRONTO FOR WINDOWS KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. OUTRAM RESEARCH LTD DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL OUTRAM RESEARCH LTD OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF OUTRAM RESEARCH LTD OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.