ERRORMSG: Microsoft Access Driver required.

Last reviewed: December 22, 2003
Article ID: 031222sab

The information in this article applies to:

• Pronto for Windows 32 bit all releases.

Symptoms

When Pronto is started the message "Pronto for Windows requires the [Microsoft Access Driver (*.mdb)] ODBC driver" is shown, and the program exits.

Cause

This problem occurs on a system that does not have the Microsoft Access ODBC driver installed.

Resolution

To install the Microsoft Access (also referred to as the JET) driver refer to the following article in the Microsoft knowledge base.

http://support.microsoft.com/default.aspx?kbid=239114

References

None

Back to Knowledge Base index

• THE INFORMATION PROVIDED IN THE PRONTO FOR WINDOWS KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. OUTRAM RESEARCH LTD DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL OUTRAM RESEARCH LTD OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF OUTRAM RESEARCH LTD OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: December 22, 2003
© 2003 Outram Research Ltd. All rights reserved.